Polaris PVCR 3300 IQ Home Aqua Operation Manual page 83

To reset the timer, push button
the respective beep follows.
At power supply elements replacement, the settings get lost. Remember to re-adjust the timer upon
battery replacement.
BATTERY CHARGING
CHARGE BASE USAGE
At using the charge base, the necessity of charging the battery, and its location are automatically
determinable by the appliance. The I/O switch on the vacuum cleaner body shall be set to "I"
position.
Position the charge base flush against the wall of the room being cleaned beside a power outlet, insert the
adapter plug into the power outlet. The indicator light on the base gets illuminated.
There shall be no obstacles at the 1-meter distance of from two lateral sides, and at the 2-meter distance
of from the front side of the charge base. There shall also be no mirrors and intensively reflective surfaces
within 15 cm above the floor in the proximity of the charge base. If there are such surfaces, cover them.
Do not place the base opposite a window to avoid potential exposure to solar radiation. Fig. 14
To perform charging, turn on the robot through the power switch, install the appliance on the base. Make
always sure the contact terminals on the base coincide with contact terminals in the appliance.
Disabled/under the sleep mode/charged long
After charging the battery, do not leave the adapter plugged in unattended.
Do not leave the charge base on the floor if the appliance is not used for long.
Attention! Shorting the charge base leads across metal items is strictly prohibited!
Do not store the appliance with the battery discharged since this can lead to its untimely failure.
Before long-term storage, half-discharge the battery. Unplug the appliance by the power switch. Do
not keep the appliance and battery under temperatures below zero.
BATTERY REPLACEMENT Fig. 15
1. Unplug the appliance by the power switch.
2. Position it upside down.
3. By means of a cross-point screw driver (beyond the delivery set), screw out the battery compartment lis
screws, and remove the lid by way of picking it up from the side of the screws location.
4. Extract a spent battery from the compartment, and disconnect its socket by pushing the lock latch of the
vacuum cleaner power socket, and pulling out the battery connector from it. To connect a new battery,
insert its connector into the vacuum cleaner power socket until the click. Carefully place the battery into
the compartment, and make sure not to jam the connective wires.
5. Install the battery compartment lid in its place. Tighten up the screws.
CLEANING AND MAINTENING THE APPLIANCE
7. Prior to maintaining and cleaning, make sure to have the appliance been disconnected from the charger,
and the latter disconnected from the power network.
and hold it down for 3 seconds. Once the programmed data deleted,
The appliance status
Charging underway
Low charge of the battery
Fully charged/ Vacuuming underway
ago
83
Indicator color
Orange, flashing
Orange, continuous
illumination
Green, continuous
illumination
No illumination