Stopping The Treatment; Removing The Electrodes; Taking Care Of Your Skin - Tens i-Pulz 2 User Manual

Do not use the i-Pulz 2 when driving or controlling heavy
machinery and not in damp areas such as in the bathroom.
Pause
If it is desired to take a break during the treatment, hold the Timer
button pressed for 2 seconds. Then the intensity goes back to zero.
To resume the treatment again, press the Timer button again for 2
seconds, and the intensity gradually increases to the intensity level
before you paused.

Stopping the treatment

If the timer is activated, the i-Pulz 2 stimulator will switch off both
channels automatically when the timer is finished. The treatment can
also be stopped manually by holding the pre-set button pressed for
2 seconds. Or by turning down the intensity until it reaches 0.0 mA.
When the intensity reaches 0.0 mA, the device will switch off after a
few minutes in order to preserve the batteries. The device can also be
switched off by pressing the Power button.

Removing the electrodes

Always switch the device off before removing electrodes!
When removing the electrodes, follow the instructions on the
packaging of the electrodes or on their instructions for use.

Taking care of your skin

After you have removed the electrodes, you can carefully clean your
skin with a mild soap. Never use aggressive substances like ether or
alcohol to remove any adhesive residues.
After the skin is cleaned, a red mark from the patches and/or
electrodes may be visible on the skin. This reaction usually disappears
quickly.
14 i-Pulz 2