Controls; Charging - Tens i-Pulz 2 User Manual

Table of Contents

Advertisement

Controls

• With the Left Up/Down button, you can step through the sessions
one by one.
• With the Right Up/Down button, you can step 10 sessions further.
• With the Timer button, you can step to the last session.
• With the pre-set button, you can step to the first session.

Charging

The i-Pulz 2 has a built-in Li-ion battery for long term use. This battery
is not user-replaceable and can only be changed by qualified service
personnel. The expected service life of the battery is five years, based
on 1000 charge cycles. The battery life strongly depends on its use.
The battery must be charged at least once per six months, to prevent
loss of total maximum capacity of the battery.
The i-Pulz 2 makes use of wireless charging technology, which means
that no cable needs to be connected to the i-Pulz 2. To get the i-Pulz 2
charged, connect the power adapter to the wireless charge-pad. Plug
the power adapter into the mains power socket. Place the i-Pulz 2 on
the centre of the wireless charge-pad. The indicator LED on the i-Pulz
2 will light-up orange, the device is now charging.
The indicator LED on the wireless charge-pad will light-up blue when it
starts charging. When the battery is almost full, the LED on the i-Pulz 2
will light up green and the blue LED of the charge-pad will turn off.
The i-Pulz 2 can be picked up from the wireless charger at any time.
The indication LED in the i-Pulz 2 stays on for 10 seconds with the
status of the battery. Red is empty, orange mid full, green is full.
When the indicator LED is red, the battery is too low to switch the
device on.
To get the best charge performance, make sure that:
• The originally supplied charger is used.
• The i-Pulz 2 is placed at the centre of the charge-pad.
• Any obstructions from/between the i-Pulz 2 and the charging
surface are removed. Also, make sure the i-Pulz 2 is placed on the
charging surface properly.
• The charging-process is done indoor at a clear space to enable
ventilation.
• To save energy, unplug the charger when not in use.
20
i-Pulz 2

Advertisement

Table of Contents
loading

Table of Contents