Toshiba GRL150-100 Series Instruction Manual page 93

• Set the cursor position in the bracket by selecting " → " or " ← " and pressing the ENTER key.
• Move the blinking cursor to a selecting character.
• Press the ENTER key to enter the blinking character at the cursor position in the brackets.
• Press the END key to confirm the entry and return to the upper screen.
To correct the entered character, do either of the following:
• Discard the character by selecting " ← " and pressing the ENTER key and enter the new
character.
• Discard the whole entry by pressing the CANCEL key and restart the entry from the first.
To enter numerical values
When the screen shown below is displayed, perform setting as follows:
The number to the left of the cursor shows the current setting or default setting set at shipment. The
cursor can be moved to upper or lower lines within the screen by pressing the
setting (change) is not required, skip the line with the
/ 4
T i m e
O C
E F
S E F
• Move the cursor to a setting line.
• Press the
or key to set a desired value . The value is up or down by pressing the
key.
• Press the ENTER key to enter the value.
• After completing the setting on the screen, press the END key to return to the upper screen.
To correct the entered numerical value, do the following.
• If it is before pressing the ENTER key, press the CANCEL key and enter the new
numerical value.
• If it is after pressing the ENTER key, move the cursor to the correcting line by pressing the
and keys and enter the new numerical value.
Note: If the CANCEL key is pressed after any entry is confirmed by pressing the ENTER key, all
the entries made so far on the screen concerned are canceled and screen returns to the upper
one.
> ! " # $ % &
' : ; , . ˆ `
T i m e / s t a r t e r
2 . 0 _
2 . 0 0
0 . 6 0
0 . 2 0 0
⎯ ⎯
92
and keys.
s
A
A
A
6 F 2 S 0 8 2 8
and keys. If
or