Toshiba GRL150-100 Series Instruction Manual page 91

• Press the "Version" on the "Set.(view)" menu.
• Select "Relay type" to display the relay type form and model number.
• Select "Serial number" to display the relay manufacturing number.
• Select "Software" to display the relay software type form and version.
• Select "PLC data" to display the PLC data.
• Select "IEC103 data" to display the IEC103 configuration data.
4.2.5.2 Settings
The "Description", "Comms", "Record", "Status", "Protection", "Binary I/P", "Binary O/P" and
"LED" screens display the current settings input using the "Set.(change)" sub-menu.
4.2.6 Changing the Settings
The "Set.(change)" sub-menu is used to make or change settings for the following items:
Password
Description
Relay address and baud rate in the RSM or IEC60870-5-103 communication
Recording setting
Status setting
Protection setting
Binary input setting
Binary output setting
LED setting
All of the above settings except the password can be seen using the "Set. (view)" sub-menu.
CAUTION
Modification of settings :
"scheme switch" and "protection element" in the "Protection" menu. Dependencies exist between
the settings in the various menus, with settings in one menu becoming active (or inactive)
depending on the selection made in another menu. Therefore, it is recommended that all necessary
settings changes be made while the circuit breaker tripping circuit is disconnected.
Alternatively, if it is necessary to make settings changes with the tripping circuit active, then it is
/ 2 V e r s i o n
• R e l a y
t y p e
• S e r i a l
N o .
• S o f t w a r e
• P L C d a t a
• I E C 1 0 3
d a t a
G R L 1 5 0 - 1 0 0 A - 1 0
- 1 0
G S 1 P M 1 - 0 1 - ∗
Care should be taken when modifying settings for "active group",
⎯ ⎯
90
6 F 2 S 0 8 2 8