Toshiba GRL150-100 Series Instruction Manual page 118

• Press the END key to return to the "LED ∗ " screen.
Repeat this process for the LEDs to be configured.
Selection of virtual LEDs
• Select "Virtual LED" on the "/2 LED" screen to display the "Virtual LED" screen.
• Select the IND number and press the ENTER key to display the "IND ∗ " screen.
Setting the reset timing
• Select "Reset" to display the "Reset" screen.
• Enter 0(=Instantaneous) or 1(=Latched) to select the reset timing and press the ENTER key.
• Press the END key to return to the "IND ∗ " screen.
Note: To release the latch state, push the [RESET] key for more than 3 seconds.
Assigning signals
• Select "Functions" on the "IND ∗ " screen to display the "Functions" screen.
• Assign signals to bits (1 to 8) by entering the number corresponding to each signal referring to
Appendix B.
Note: If signals are not assigned to all the bits 1 to 8, enter 0 for the unassigned bit(s).
• Press the END key to return to the "IND ∗ " screen.
Repeat this process for the outputs to be configured.
4.2.7 Testing
The sub-menu "Test" provides such functions as disabling the automatic monitoring function and
forced operation of binary outputs.
/ 3 V i r t u a l
• I N D 1
• I N D 2
I N D ∗
/ 4
• R e s e t
• F u n c t i o n s
/ 5 R e s e t
R e s e t
I n s t / L a t c h
/ 5 F u n c t i o n s
B I T 1
5 1 _
B I T 2
5 4
B I T 8
7 8
⎯
117
L E D
0 _
⎯
6 F 2 S 0 8 2 8