Compaq AlphaServer GS80 User Manual page 53

1. Open a Command Prompt window by double-clicking the MSDOS Command
desktop icon.
2. In the Command Prompt window enter the following (shown here in bold);
press the Enter key at the end of each line:
C:\> cd c:\cwks\bin
C:\CWKS\Bin> configure_telnet_listener m n
where m is the system number (1 to 32) of the GS80/160/320 system, and n
is the number of consoles (1 to 8) you want to enable. Entering a number
that is less than the number of consoles in the system enables the first n
consoles. For example, if the system has six consoles and you enter the
number 5 for n, consoles 1 through 5 are enabled.
Entering the command without the arguments displays the help text shown
in Figure 3–5.
3. Start a telnet session by entering:
C:\CWKS\Bin> telnet host_name port_number
where host_name is the fully qualified address or the IP address of the SMC
on the corporate network, and port_number is the port number of the
console to which you want to connect (see Table 3–2 on the next page).
4. When prompted for a username and password, enter those of a valid
ConsoleWorks account.
NOTE: By using the port number 5180 in the above command you can connect
directly to ConsoleWorks and use its command line interface. This is an
alternative to ConsoleWorks Terminal (CWTerm). For more information
on the command line interface, see the CWTerm User Guide in the SMC
documentation desktop folder on the SMC system. The CWTerm
program can be found in c:\cwks\bin\cwterm.exe.
ConsoleWorks 3-11