Transmission Installation - Toro Workman HDX Auto Service Manual

Transmission Installation (Fig. 52)
1. Carefully lower and rotate transmission to allow it to
clear engine and tabs on engine/transmission mount.
Support transmission in position.
2. Loosely secure transmission to tabs on engine/trans-
mission mount with two (2) flange head screws and
flange nuts. Tighten fasteners only enough so that trans-
mission can be moved for alignment purposes.
3. Carefully position spanner plate to air inlet housing
on engine and transmission. Secure spanner plate to air
inlet housing with five (5) washer head screws (Fig. 23).
Do not install screws in the two (2) holes closest to the
air intake end of the spanner plate. These holes will be
used to secure the CVT enclosure cover.
IMPORTANT: As the screws used to secure the
spanner plate to the transmission are installed,
move transmission so the mounting holes of the
spanner plate align with the transmission. Be care-
ful to prevent spanner plate distortion as screws are
installed and tightened.
4. Align the transmission to the spanner plate so that
the mounting holes align. Secure spanner plate to trans-
mission with five (5) flange head screws (Fig. 23).
5. Secure the transmission in place by fully tightening
the two (2) flange nuts and flange head screws.
Drive Train
6. On vehicles equipped with four wheel drive kit, se-
cure front differential driveshaft to the front of the trans-
mission (see Differential Driveshaft in the Service and
Repairs section of Chapter 8 − Four Wheel Drive Kit).
7. Install shift cable clevis to transmission lever and se-
cure with clevis pin and hairpin (Fig. 53).
8. Connect wire harness connectors to rotary switch
and speed sensor on front of transmission (Fig. 53).
9. Install primary clutch to engine and secondary clutch
to transmission (see Primary and Secondary Clutches in
this section).
10.Install rear driveshaft to machine (see Rear Drive-
shaft in this section).
11. Make sure that the transmission lever on the seat
base console moves fully between all transmission posi-
tions. If necessary, adjust shift cable to allow correct
lever movement (see Shift Cable Adjustment in the Ad-
justments section of this chapter).
12.Properly fill transmission with Dexron VI transmis-
sion fluid.
13.Lubricate grease fittings on driveshaft(s).
14.Lower cargo bed (if installed).
Page 4 − 50 Workman HDX Auto