Toro Workman HDX Auto Service Manual page 29

DANGER
Because gasoline is highly flammable, use cau-
tion when storing or handling it. Do not smoke
while filling the fuel tank. Do not fill fuel tank
while engine is running, hot or when vehicle is in
an enclosed area. Always fill fuel tank outside
and wipe up any spilled fuel before starting the
engine. Store fuel in a clean, safety−approved
container and keep cap in place. Use fuel for the
engine only; not for any other purpose.
Check Fuel Lines and Connections
Check fuel lines and connections periodically as recom-
mended in the Operator's Manual. Check lines for dete-
rioration, damage, leaks or loose connections. Replace
hoses, clamps and connections as necessary.
Fuel Tank Removal (Fig. 8)
1. Park vehicle on a level surface and engage parking
brake.
2. Raise or remove the cargo bed or other attach-
ment(s). If bed is raised, place safety support on lift cylin-
der.
3. Make sure that the engine is stopped and the key is
removed from ignition switch. Allow engine to cool.
4. Disconnect wire harness connector from fuel pump
assembly on fuel tank.
5. Note routing of fuel hoses for installation purposes
(Fig. 9). Disconnect fuel hoses from fuel pump assembly
and rollover valve. Plug fuel hoses to prevent leakage or
contaminant entry.
6. Remove washer head screws (item 8) and retainer
plate (item 7) that secure fuel tank to vehicle.
7. Remove fuel tank from vehicle.
Workman HDX Auto
Fuel Tank Installation (Fig. 8)
1. Position fuel tank to support tube.
2. Remove plugs placed in fuel hoses during fuel tank
removal. Connect fuel hoses to fuel pump assembly and
rollover valve (Fig. 9). Secure fuel hoses with hose
clamps.
3. Connect wire harness connector to fuel pump as-
sembly.
4. Position retainer plate (item 7) to tank and frame.
Make sure that fuel hoses are correctly placed under re-
tainer. While pressing down on retainer plate to best re-
tain tank, install and tighten washer head screws (item
8) to secure fuel tank to vehicle.
5. Lower or install the cargo bed or other attachment(s).
6. Fill fuel tank. Check for fuel leakage and correct if
found.
ROUTE HOSES/WIRES UNDER PLATE
3
1. Retainer plate
2. Fuel supply hose
Page 3 − 9
2
1
Figure 9
3. Tank vent hose
Kohler Gasoline Engine