Adjustments; Shift Cable Adjustment - Toro Workman HDX Auto Service Manual

Adjustments

Shift Cable Adjustment

For correct vehicle operation, shift cable adjustment
should allow the transmission lever on the seat base
console (Fig. 10) to move fully between all transmission
positions.
1. Park vehicle on a level surface, raise and support ve-
hicle cargo bed (if installed), shut engine off and engage
the parking brake. Remove key from the ignition switch.
2. Adjust jam nuts on shift cable (item 6 in Fig. 11) to al-
low full range of motion between PARK and DRIVE at
transmission lever. If necessary, additional cable adjust-
ment can be made with jam nuts on cable clevis (item 7
in Fig. 11) at transmission lever.
3. Make sure that jam nuts are properly tightened after
adjustment.
4. Remove bed support from cargo bed lift cylinder and
lower bed after shift cable adjustment is completed.
Workman HDX Auto
1
2
1. Transmission lever
5
7
1. Transmission
2. Shift cable
3. Hairpin
4. Clevis pin
Page 4 − 11
Figure 10
2. Transmission positions
1
3
4
7
2
6
Figure 11
5. Cable clevis
6. Jam nut (2)
7. Jam nut (2)
Drive Train