Parking Brake Cable - Toro Workman HDX Auto Service Manual

Parking Brake Cable

RIGHT
FRONT
9
3
2
17
1. Lever support assembly
2. Parking brake lever
3. Spacer (2)
4. Curved washer
5. Clevis pin
6. Lock nut (2)
Removal (Fig. 13)
1. Park vehicle on a level surface, raise and support ve-
hicle cargo bed (if installed), shut engine off and engage
the parking brake. Remove key from the ignition switch.
2. Remove brake lever handle from parking brake lever
and loosen set screw on parking brake lever knob
(Fig. 14). Turn knob on parking brake lever counter-
clockwise all the way to loosen brake cable adjustment.
3. Remove knobs from control levers and then remove
center console control plate to gain access to parking
brake cable in console.
Chassis
5
4
13
6
3
10
6
1
7. Bellcrank (2)
8. Cap screw (2)
9. Hair pin
10. Flat washer
11. Hair pin
12. Clevis pin
15
14
7
11
Figure 13
1. Parking brake lever
2. Knob
Page 5 − 22
8
12
13. Parking brake cable
14. Retaining ring
15. Speed control lever
16. Hydraulic lever
17. Shift lever
1
2
Figure 14
3. Set screw
Workman HDX Auto
16
3