Toro Workman HDX Auto Service Manual page 44

12.Install hydraulic pump to machine (see Gear Pump
(Vehicles with Standard Hydraulics) or Gear Pump (Ve-
hicles with High Flow Hydraulics) in the Service and Re-
pairs section of Chapter 7 − Hydraulic System).
13.Install primary clutch to engine crankshaft. Make
sure that CVT drive belt and enclosure cover are proper-
ly installed (see Primary and Secondary Clutches in the
Service and Repairs section of Chapter 4 − Drive Train).
14.Secure carbon canister to pump mount (see Fuel
Evaporative Control System in this section).
15.Connect radiator hoses to engine and secure hoses
with hose clamps. Fill cooling system (see Radiator in
this section).
16.Secure wire harness, hoses and cables to the engine
with clamps and cable ties in locations noted during en-
gine removal.
Kohler Gasoline Engine
17.Install the exhaust system (see Exhaust System in
this section).
18.Install air intake hose from engine to air cleaner as-
sembly and secure hose with hose clamps (see Air
Cleaner System in this section).
19.Install a new engine oil filter. Fill engine with new en-
gine oil.
20.Connect positive (+) and then negative (−) battery
cables to the battery.
21.Check operation of accelerator cable and adjust if
necessary (see Adjust Accelerator Control in the Adjust-
ments section of this chapter).
22.Lower cargo bed or install bed or attachment(s).
Page 3 − 24
Workman HDX Auto