Installation; Preparing The Machine - Toro Workman HDX Installation Instructions Manual

Installation

Media and Additional Parts
Description
Compression spring tool
CVT-intake hood assembly (Workman
HDX-Auto machines only)
1

Preparing the Machine

No Parts Required
Procedure
1. Park the machine on a level surface.
2. Engage the parking brake.
3. Raise or remove the bed from the machine (if
equipped).
Note:
Refer to the machine Operator's Manual
for more detailed information on raising and
removing the bed.
4. Shut off the engine, remove the key, and allow
the machine to cool.
5. Disconnect the battery; refer to the Operator's
Manual.
6. While grasping the hood in the headlight
openings, lift up on the hood to release the lower
mounting tabs from the slots in the bumper
(Figure 1).
Qty.
1 Installing the compression spring.
1
Installing the CVT-intake hood assembly.
1. Hood
7. Pivot the bottom of the hood upward until you
can pull the top mounting tabs from the frame
slots (Figure
8. Pivot the top of the hood forward and unplug the
wire connectors from the headlights
9. Remove the hood.
3
Use
Figure 1
1).
g010314
(Figure 1).