Parking Brake Caliper - Toro Workman HDX Auto Service Manual

Parking Brake Caliper

RIGHT
FRONT
4
1. Transmission
2. Rear differential
3. Parking brake cable
4. Retaining ring (2)
5. Clevis pin
Disassembly (Fig. 17)
1. Park vehicle on a level surface, raise and support ve-
hicle cargo bed (if installed), shut engine off and engage
the parking brake. Remove key from the ignition switch.
2. Remove brake lever handle from parking brake le-
ver. Loosen set screw in parking brake lever knob
(Fig. 18). Turn knob on parking brake lever counter-
clockwise all the way to loosen brake cable adjustment.
3. Jack up and support rear of vehicle (see Jacking Ve-
hicle in the Safety Instructions section of Chapter 1 −
Safety).
Chassis
3
13
23 to 27 ft−lb
(32 to 36 N−m)
Grease
1
6. Hairpin
7. Parking brake rotor
8. Parking brake caliper
9. Flange nut (2)
10. Flange head screw (2)
5
4
6
14
Figure 17
1. Parking brake lever
2. Knob
Page 5 − 24
2
7
9
12
8
11. Brake mount plate
12. Parking brake spacer
13. Socket head screw (4)
14. Rear driveshaft
1
2
Figure 18
3. Set screw
Workman HDX Auto
10
11
3