Table of Contents
Advertisement
Installation
The Transpro 80 machine is intended for use with
Greensmaster 800, 1000, 1010, 1600, 1610, 2000,
and 2600 machines, as well as Flex 18, 21, 1800,
1820, 2100, 2120 machines, and eFlex 1800, 1820,
2100, 2120 Walk Greensmaster machines.
Mounting the Tongue
Assembly
1.
Insert the tongue assembly into the frame
assembly while aligning the rear mounting holes
(Figure
1).
2.
Secure the tongue assembly into the frame
assembly with a clevis pin, 2 washers and 2
cotter pins
(Figure
1. Tongue assembly
2. Frame assembly
3. Clevis pin
1).
Figure 1
4. Cotter pin
5. Washer
Mounting the Axle and
Ramp (Model 04245) or Rail
(Models 04244 and 04247)
Assemblies
1.
Refer to
Figure 2
holes that you should use to fit the width of your
greensmower.
1. Greensmaster 1600,
2600, 1000 with groomer,
and 2000 machines with
groomer
2. Greensmaster 800, Flex
18, Flex 1800, 1820, and
eFlex 1800, and 1820
machines
Important:
has a groomer attached, it will be mounted
differently than above; refer to the following
list:
•
Greensmaster 1000/2000 or 2100 with
groomer: The left side should be set to
g215365
position #3 and the right side should be set
to #1.
•
Greensmaster 1800/eFlex 1800 with
groomer: The left side should be set to
position #2 and the right side should be set
to #3.
2.
Mount the axle assembly and a ramp assembly
(Figure
3) or rail assembly
end of the frame with 2 bolts (3/8 x 3 inches),
4 washers, and 2 nuts.
2
to determine which mounting
Figure 2
3. Greensmaster 1000, Flex
21, 2000, Flex 2100, 2120
and eFlex 2100, and 2120
machines
If your Greensmaster machine
(Figure
4) to each
g014662
Advertisement
Table of Contents
