Installation; Loose Parts; Preparing The Machine - Toro Workman GTX Series Installation Instructions Manual

Installation

Loose Parts

Use the chart below to verify that all parts have been shipped.
Description
No parts required
Spreader-mount frame
Snap pin
Clip bushing
Spreader-pivot shaft
Left spreader ramp
Right spreader ramp
Flange-head screw ( 5/16 x 1-1/2 inches)
Flange nut (5/16 inch)
Clevis pin
Hairpin cotter
No parts required
No parts required
Important: The total load capacity when this kit is installed is 45 kg (100 lb). When installing the spreader, verify
that the weight of the spreader loaded with seed or fertilizer does not exceed 45 kg (100 lb), or damage may occur.
Important: After installing the spreader mount to the machine, the length of the front or rear of the machine extends.
Ensure that there is always adequate clearance when operating the machine with the spreader mount installed.
If installed on the front of the machine, use caution when approaching hills, as the extension of the front of the
machine makes it more likely to damage turf.

Preparing the Machine

1. Move the machine to a level surface (box A of
2. Engage the parking brake (box B of
3. Shut off the engine (box C of
4. Remove the key from the ignition (box D of
Qty.
–
1
2
2
1
1
1
4
4
1
1
–
–
Figure 1).
Figure 1).
Figure 1).
Figure 1).
Figure 1
Prepare the machine.
Install the walk-speader mount (for machines with a plastic
cargo bed).
Install the walk-speader mount (for machines with a steel
cargo bed).
Install the walk-speader mount (for machine with or without
the Brush Guard Kit installed).
2
Use