Seat Base - Toro Workman HDX Auto Service Manual

Seat Base

12 in−lb (maximum)
(1.3 N−m)
RIGHT
FRONT
1. LH (operator) seat
2. RH (passenger) seat
3. Washer head screw (10)
4. Shift decal
5. Shift plate
6. Carriage bolt (8)
7. Seat bracket (4)
8. Seat base
Removal (Fig. 33)
1. Park vehicle on a level surface, raise and support
bed (if installed), shut engine off and apply the parking
brake. Remove key from ignition switch.
2. Loosen hose clamps and remove CVT intake hose
from ROPS cover and CVT enclosure cover (Fig. 34).
Chassis
3
4
5
8
9. Flange nut (8)
10. U−clip nut (8)
11. Mudflap (2)
12. Flat washer (8)
13. Flange head screw (4)
14. Flange nut (4)
15. Control plate
16. Socket head screw
2
16
15
18
17
21
20
19
22
14
10
Figure 33
3. Lift engine coolant overflow tank from slots in rear of
ROPS cover. Position overflow tank away from seat
base.
4. Remove six (6) carriage screws and flange nuts that
secure ROPS cover to ROPS frame. Remove cover
from vehicle (Fig. 35).
Page 5 − 42
23
12
11
12
6
9
7
17. Spacer
18. Nylon washer
19. Flat washer
20. Spring washer
21. Detent lever
22. Flange head screw
23. Socket head screw (8)
Workman HDX Auto
1
13