Table of Contents
Advertisement
6.1.3
Connecting VDSL2 and ADSL2(2+) WAN
The device supports VDSL2 / ADSL2(2+) with a signal bandwidth of up to profiles 17a / 30a
/ 35b. The WAN port provides a single xDSL interface through an RJ-11 port.
The specifications of the xDSL interface include the following:
VDSL2/ADSL2+ Data Engine:
Supports all VDSL2 (G.993.21), ADSL2+ (G.992.5), ADSL2 (G.992.3) and ADSL
•
full-rate (G.992.1)
Supports retransmission (G.998.4)
•
•
Supports G.Vector (G.993.5)
•
Supports G.Bond (G.998.2)
High-performance VDSL2 supports profile up to 35b, 30a, 17a, 12x, 8x and
•
ADSL2+ with on-chip Interleaver/Retransmission Memory for Annex-Q
Supports simultaneous Retransmission and Vectoring
•
ADSL:
RFC 2684 in Routed (IPoA) and Bridged (ETHoA) modes, supporting LLC-SNAP
•
and VC-Multiplexed encapsulations over AAL5
•
ATM UNI 4.1 compliant
UBR, CBR, VBR classes of service
•
RFC 2364 PPPoA
•
•
RFC 2516 PPPoE over ATM
Up to 8 PVCs
•
VDSL:
•
ITU G.991.2 Annex E for Ethernet, also known as EFM or 2Base-TL, as defined in
IEEE 802.3ah
802.1q VLANs over EFM
•
•
PPPoE
Note:
The xDSL interface is a customer-ordered item. For more information, contact
your AudioCodes sales representative.
Cable specification:
Connector: RJ-11
Connector Pinouts:
Hardware Installation Manual
Table 6-2: RJ-11 Connector Pinouts for WAN DSL
Pin
3
CH0 – P/TIP
4
CH0 – N/RING
1
Not connected
2
Not connected
5
Not connected
6
Not connected
Function
30
Mediant 500Li
Document #: LTRT-10605
Advertisement
Table of Contents
