Table of Contents
Advertisement
Hardware Installation Manual
Notes:
•
The SFP module and fiber-optic cable are not supplied. It is recommended that you
purchase the SFP modules from AudioCodes. For a list of orderable SFP modules,
see Appendix
This AudioCodes device has been evaluated with the laser transceiver modules
•
(SFP) listed in Appendix
installing the device is solely responsible for the usage of correct SFP modules to
comply with local, applicable laser safety requirements and certification.
AudioCodes will not be held responsible for any damage to human body or
equipment caused as a result from the usage of SFP modules that are not listed in
Appendix
Cable specifications:
WAN fiber-optic interface: LC-type plug
WAN copper interface: see Section 6.1.1 on page 27
To connect the fiber-optic WAN GbE port:
1.
Remove the protective dust plug from the SFP transceiver module. Save the dust plugs
for future use.
2.
Immediately connect a cable with LC-type plugs to the SFP transceivers (labeled GE
SFP).
3.
Connect the other end of the cable to the fiber network.
Mediant i-Series
A
on page 47, or contact your AudioCodes sales representative.
A
on page 47. If other SFP modules are used, the person
A
on page 47.
Figure 6-2: Removing Protective Dust Plug
Figure 6-3: Cabling Fiber-Optic WAN GbE Port
29
6. Cabling the Device
Mediant 500Li
Advertisement
Table of Contents
