AudioCodes i Series Hardware Installation Manual page 17

Hardware Installation Manual
Item # Label
4
5 //
6 S0 (Slot 0)
WAN
7 S1 (Slot 1)
GE LAN
8
9 S2 (Slot 2)
BRI or FXS
S3 (Slot 3)
FXS
-
10
11
12 -
Mediant i-Series
USB 3.0 port, which can be used for the following:
3G cellular WAN modem for primary or backup WAN

Third-party external USB hard drive or flash disk (disk on key) for

USB storage capabilities (for example, for configuration file)
Note: The USB port is not provided when the device is ordered with
LTE cellular support.
Reset pinhole button for resetting the device or for restoring it to factory
defaults.
To restore the device to factory defaults, do the following: With a paper
clip or any other similar pointed object, press and hold down the pinhole
button for at least 15 seconds, but no longer than 25 seconds.
WAN interface ports, which can be any of the following (depending on
ordered configuration):
GE: GE over Copper

GE SFP: SFP module

DSL: DSL interface

Note: For available WAN configurations, contact your AudioCodes sales
representative.
Up to four Gigabit Ethernet (1000Base-T) ports (RJ-45) for connecting
to LAN network such as IP phones, computers, and switches. These
ports support half- and full-duplex modes, auto-negotiation, and straight
or crossover cable detection.
Wi-Fi pinhole button for enabling and disabling Wi-Fi. Use a paper clip
or any other similar pointed object to press the button.
Note: The Wi-Fi button is available only for models ordered with the Wi-
Fi functionality.
Depending on ordered hardware configuration, Slot #2 can occupy
either up to four ISDN BRI port interfaces (RJ-45), or four analog FXS
port interfaces (RJ-11). For FXS interfaces, Slot #3 can occupy up to
four FXS port interfaces.
Note: For orderable FXS or BRI interfaces, please contact your
AudioCodes sales representative.
Cellular antennas for 4G LTE network.
Note: The antennas are applicable only to models ordered with the 4G
LTE cellular functionality.
SIM card slot for 4G LTE cellular.
Note: The SIM card slot is applicable only to models ordered with the
4G LTE cellular functionality.
Multiple-input and multiple-output (MIMO) 2Tx/2Rx antennas, operating
in the 2.4 GHz frequency range for wireless LAN 802.11n/b/g (Wi-Fi)
access point functionality.
Note: The antennas are applicable only to models ordered with the Wi-
Fi functionality.
17
3. Physical Description
Description
Mediant 500Li