Example Of Connecting Two Mp-118 Devices; Figure 3-6: Example Of Connecting Two Mp-118 Devices - AudioCodes MediaPack MP-11 Series Fast Track Manual

3.4.4

Example of Connecting Two MP-118 Devices

This example applies to H.323 and SIP.
devices' internal routing tables. The phone '2001' is connected to the first channel of gateway
10.2.222.108, and phone '2101' is connected to the first channel of gateway 10.2.222.107.
To make a call between two gateways, lift the receiver of phone '2001'; you hear a dial tone and
the first Channel Status LED lights up. Dial 2101; after dialing the last digit phone '2101' rings.
Note 1:
Note 2:

Figure 3-6: Example of Connecting Two MP-118 Devices

Analog Fast Track Guide
Figure 3-6
The prefixes you choose in the 'Tel to IP Routing' table must differentiate the
gateways from each other to ensure correct routing. In the example, using the
first digit (2) doesn't differentiate the devices, thus 2 digits of the phone
number are used.
To enable phones connected to the same MediaPack to communicate with
each other, define in the internal routing table the IP address and
corresponding phone numbers of the device itself.
24
below shows an example of two MP-118/FXS
Document #: LTRT-59802
MediaPack