Disabling The Link Function - Brother 884-T23 Operation Manual

Memo
• The embroidering screen settings specified in step
c
are saved even if
continue embroidering after embroidering is
finished.
• If the machine is turned off while it is embroidering,
the resume operation can be used the next time it
is turned on.
■ Embroidering a pattern received in the
embroidering settings screen
If [Send to] is set to [Embroidering Settings Screen], the
embroidery pattern sent to the machine will appear in the
embroidering settings screen.
a After the embroidery pattern has been sent to the
machine, the embroidering settings screen appears.
 The opened embroidery pattern appears in the
pattern display area with the icon for the Link
function.
• USB cable connection
1
2
3
1 Icon for Link function
2 10-digit machine ID
3 Number of the pattern in
the queue
Memo
• While the machine is connected to the computer,
the machine's status can be displayed by using a
function of the embroidery editing software. If
multiple machines are connected at the same time,
check the status of the machines using the 10-digit
machine ID or machine's name that appears in the
machine's screen. The following information can be
viewed from the computer.
- Machine's status
- Information on the embroidery data being
embroidered and received by the machine (time
until the next time that the machine stops,
number of color changes, embroidering time,
maximum embroidery speed, pattern size, size of
frame being used on the machine)
b After the desired settings have been specified, touch
to continue to the embroidering screen.
120
was touched to
• Wireless LAN connection
1
2
3
1 Icon for Link function
2 The machine's name
3 Number of the pattern in
the queue
c Touch , and then press the "Start/Stop"
button to start embroidering.
 When embroidering is finished, the following
message appears.
d To open another pattern sent from the computer,
touch , and then repeat the procedure starting
a
from step to continue embroidering.
To stop embroidering or to embroider the same pattern
again, touch .
Memo
• If the machine is turned off while it is embroidering,
the resume operation can be used the next time it
is turned on.
• The embroidering screen settings specified in step
a
are saved even if
continue embroidering after embroidering is
finished.

Disabling the Link function

a Touch , then
 The general settings screen appears.
Locate [Link] in the Settings pages.
b
c Touch [OFF] to disable the Link function.
 When the message to finish the Link mode appears,
touch .
d Turn off the machine.
Note
• When you turn off the machine, wait for about 5
seconds before turning on the machine again.
was touched to
.