Brother 884-T23 Operation Manual page 154

Error messages
32 OK to recall and resume previous memory?
33 OK to revert to previous color changes?
34 OK to separate the combined border pattern?
35 Panel communication error.
36 Pattern extends to the outside of embroidery frame.
Add no additional characters.
37 Pattern extends to the outside of embroidery frame.
This function cannot be used at this time.
38 Picker error
39 Please set up the "Thread antenna"
40 Power supply voltage error.(24V high)
41 Power supply voltage error.(24V low)
42 Power supply voltage error.(40V high)
43 Power supply voltage error.(40V low)
44 Press the unlock key to unlock the machine.
45 Preventive maintenance is recommended.
46 Select a pattern.
47 Set the clock.
48 Stop while needle bar case transferring.
152
Cause/solution
This message is displayed when the machine is turned off, then on again
before embroidering is completed. Touch
If the embroidering screen was displayed before the machine was turned off,
back up several stitches, and then continue embroidering. (page 92)
This message is displayed when
being changed.
This message is displayed when a combined border pattern is being rotated
in the embroidering settings screen.
When this message is displayed, consult your nearest authorized Brother
dealer.
This message is displayed when the entered character patterns exceed the
width of the embroidery frame.
This message is displayed when the font of the character pattern is changed
to one with a larger size, causing the pattern to extend beyond the
embroidery frame.
This message is displayed when the thread picker (page 35) does not
operate correctly. Remove the thread entangled on the thread picker, and
then touch .
This message is displayed when thread guide assembly support is not
prepared. Prepare the thread guide assembly. (page 19)
When this message is displayed, consult your nearest authorized Brother
dealer.
When this message is displayed, consult your nearest authorized Brother
dealer.
When this message is displayed, consult your nearest authorized Brother
dealer.
When this message is displayed, consult your nearest authorized Brother
dealer.
This message is displayed when the thread trimming button is pressed
before the machine is unlocked. Touch
trimming function.
This message is displayed when the machine needs maintenance.
(page 143)
This message is displayed when there is no embroidery pattern selected and
the "Start/Stop" button is pressed.
This message is displayed when the time/date is not set. Set time/date.
(page 23)
This message is displayed when the machine has stopped while the needle
bar case is moving. Touch
case.
to resume embroidering.
is touched while thread colors are
to use the thread
to automatically reset the needle bar