Chapter 1 Getting Ready; Names Of Machine Parts - Brother 884-T23 Operation Manual

1
Chapter
Note
• Be sure to install the latest software.
Refer to "UPDATING YOUR MACHINE'S
SOFTWARE" on page 158.

NAMES OF MACHINE PARTS

■ Main parts
m
n
o
a
b
c
d
e
p
q
r
s
GETTING READY
l
k
j i
h
g
f
v
u
t
Bottom
1 Thread tension knobs (page 104)
2 Needle bar case
Moves to the left and right to move the needle to the
embroidering position.
3 Lower thread guide
4 Carriage
Attach the embroidery frame to the carriage. When the
machine is turned on or when the machine is embroidering, the
carriage moves forward, backward, left and right.
5 Hook cover/Hook (page 35)
6 Feet (page 18)
7 Embroidery light
The brightness of the embroidery light can be adjusted in the
settings screen.
8 Embroidery frame holder (page 21)
9 Operation panel (page 12)
0 Spool stand (page 20)
A Thread guide assembly support
B Thread guide (page 78)
C Upper thread guide (page 78)
D Thread guide pins (page 79)
E Middle thread guide (page 79)
F Touch pen holder
Use the touch pen holder to hold the touch pen when not in
use.
G USB port for media (page 116, page 159)
In order to send patterns from/to USB media, plug the USB
media directly into the USB port.
H USB port for computer (page 116)
In order to import/export patterns between a computer and the
machine, plug the USB cable into the USB port.
I Main power switch (page 22)
Use the main power switch to turn the machine on ("I") and off
("O").
Do not turn the power on soon after turning the power off. It is
recommended that you wait 5 seconds before turning the
power back on.
J Power cord receptacle (page 22)
K Ventilation slots
The ventilation slots allow the air surrounding the motor to
circulate. Do not cover the ventilation slots while the machine is
being used.
L Handwheel
Rotate the handwheel to move the needle up and down. Be
sure to rotate the handwheel toward the LCD panel.
GETTING READY
1
11