Checking The Position Of The Pattern; Checking The Needle Drop Point With The Embroidery Crosshair Positioning Laser; Checking The Embroidery Pattern - Brother 884-T23 Operation Manual

CHECKING THE POSITION OF THE
PATTERN
The pattern is usually placed at the center of the
embroidery frame. If you want to change where in the
fabric the pattern will be embroidered, you can check the
position before starting embroidering.
Checking the needle drop point with the
embroidery crosshair positioning laser
a Make sure that the embroidery crosshair positioning
laser on/off key appears as
 The embroidery crosshair positioning laser indicates
the needle drop point.
• Each touch of the key turns the setting either on or off.
Embroidery crosshair
positioning laser lights
up.
Memo
• With certain types of embroidery frames, the
embroidery crosshair positioning laser function
cannot be used.
• If the surface of the fabric is too uneven or rough,
check and adjust the alignment of the embroidery
crosshair positioning laser and the needle drop
point before starting to embroider.
• When using the cap frame, check and adjust the
alignment of the embroidery crosshair positioning
laser and the needle drop point before starting to
embroider.
• You can align the embroidering position with the
embroidery crosshair positioning laser function.
(page 98)
74
.
Embroidery crosshair
positioning laser lights
off.
■ Adjusting the brightness of the embroidery
crosshair positioning laser
a Touch , then
 The general settings screen appears.
b Locate [Crosshair Positioning Laser Brightness] in the
Settings pages.
c Touch .
 The embroidery crosshair positioning laser lights up,
and the brightness adjustment screen for the
embroidery crosshair positioning laser appears.
d Touch or to adjust the brightness of the
embroidery crosshair positioning laser.
e Touch twice to return to the previous screen.

Checking the embroidery pattern

The carriage moves and shows the pattern position. Watch the
embroidery frame closely to make sure the pattern will be
embroidered in the right place. At this time, using the
embroidery crosshair positioning laser function, the pattern
position is projected on the fabric and you can check it more
clearly.
a Make sure that the embroidery crosshair positioning
laser on/off key appears as
 The embroidery crosshair positioning laser indicates
the needle drop point.
b Touch .
 The embroidery frame moves to show the
embroidery area.
Memo
• The presser foot is slightly lowered when the
embroidery crosshair positioning laser function is
set to [OFF].
.
.