Brother 884-T23 Operation Manual page 101

c Select the pattern.
d Touch to display the embroidering settings
screen.
e Touch in the embroidering settings screen.
1 Switch on/off the embroidery crosshair positioning laser.
Memo
• The embroidery crosshair positioning laser lights
up to indicate the needle drop point.
• With certain types of embroidery frames, the
embroidery crosshair positioning laser function
cannot be used.
• If the surface of the fabric is too uneven or rough,
check and adjust the alignment of the embroidery
crosshair positioning laser and the needle drop
point before starting to embroider.
• When using the cap frame, check and adjust the
alignment of the embroidery crosshair positioning
laser and the needle drop point before starting to
embroider.
f If a message appears, indicating that the move and
rotate settings will return to the original ones, touch
.
g From the reference points shown in the screen, select
the point to be used for aligning the pattern.
For this example, select the point in the lower-left
corner of the pattern.
Memo
• Even if the embroidery crosshair positioning laser
function is set to [OFF], the embroidery crosshair
positioning laser appears so that the pattern can be
aligned. When pattern alignment is completed, the
embroidery crosshair positioning laser goes off.
• In order for the embroidery crosshair positioning
laser to be easily seen, the brightness of the
embroidery light will be slightly decreased if it was
set at a high setting.
h Touch
i Select the direction (from the reference point) to be
used as a reference for aligning the pattern.
For this example, select the arrow pointing to the right
as the reference direction.
1
1 Cancel the pattern alignment settings.
2 Return to the previous screen.
j Touch
k Touch the positioning keys to move the embroidery
frame until the embroidery crosshair positioning laser
and the center of the mark are aligned.
To change the speed that the frame moves, use the
frame movement speed keys. If it is difficult to make a
precision alignment, touch a frame movement speed
key for a slower speed.
1 Positioning keys
2 Frame movement speed keys
3 Center of mark
4 Embroidery crosshair positioning laser
ADVANCED EMBROIDERY
.
1
.
c
3
2
1
2
99