Visual Inspection Of The Chassis - Labrie TOP SELECT Maintenance Manual

DANGER!
Do not use props with a loaded body.
Never stand under a loaded body.
Figure 4-11 Air hose

Visual Inspection of the Chassis

WARNING!
Always set the body safety prop when performing inspection underneath a raised body.
Failure to do so may result in severe injury, or even death.
N : Refer to the chassis manufacturer's manual for information on how to proceed with the
OTE
inspection of the chassis.
To prepare the truck for the chassis inspection, do the following:
1.
Follow the three preparation steps as described on page 33 before carrying out the visual
inspection operations.
2. Start the truck's engine.
3. Turn ON the pump switch to engage the hydraulic system.
4. Raise the body high enough to set the body safety prop (see Body Safety Prop on page 14).
5. Lower the body so that it rests on the prop.
6. Turn OFF the pump switch.
7.
Stop the engine.
8.
Apply the Lockout/Tagout procedure (see Lockout/Tagout Procedure on page 22).
Monthly Visual Inspection 41