Loading Bucket Daily Cleaning - Labrie TOP SELECT Maintenance Manual

12. When the first partition is clean, release its locks to help the water evacuate.
13.
Repeat Steps 11 and 12 to clean the remaining partitions.
Progress towards the rear of the body until you reach the tailgate.
14.
Once all partitions have been properly cleaned up, exit the body
15.
Start the truck's engine.
16.
Turn ON the pump switch.
17.
Lower the body.
18.
Put the tailgate safety prop back to its home position.
19.
Close the tailgate
20. Turn OFF the pump switch.
21. Stop the engine.
22. Clean the body's exterior walls with water and soap.
23. Rinse.
WARNING!
Be careful not to use pressurized water on cylinder heads, joints or electrical devices such
as limit/proximity switches.

Loading Bucket Daily Cleaning

After emptying the T
procedure:
1.
Start the truck's engine.
2.
Turn ON the pump switch.
3.
Set the loading bucket to its resting place.
4.
Turn OFF the pump switch.
5.
Stop the engine.
6. Apply the Lockout/Tagout procedure (see Lockout/Tagout Procedure on page 22).
7. Remove all the separators and clean them thoroughly (see Loading Bucket Partition Adjustment
on page 62).
8.
Using a shovel and a broom, remove as much dirt and materials as possible.
9.
Use pressurized water to wash the loading bucket.
10.
When most of the water has drained out of the bucket, put the separators back in place.
N : If your T S
OTE OP ELECT
loading bucket using same procedure.
S ™ unit of all its contents, perform the following bucket cleaning
OP ELECT
™ unit has two loading buckets, proceed with the cleaning of the other
General Cleanliness 29