Table of Contents
Advertisement
If you have not already completed the instructions on the Quick Start page packed with your XstreamCORE, use the following instructions to
install the XstreamCORE.
Unpack the packing box; verify contents
•
The XstreamCORE.
o
Record the serial number, default username, and
default password located on the bottom of the
unit:
S/N: __________________________________
Default Username: ______________________
Default Password: _______________________
The username and password are needed to
access XstreamVIEW, SSH, and SFTP services via
the Ethernet management ports.
During the first login to XstreamVIEW or SSH, the
XstreamCORE will prompt you to change the unit's default
password.
•
Power cords
•
"L" brackets for mounting in a 19" rack
•
Ethernet cable
•
RS-232 cable
Install the XstreamCORE
1. Place the XstreamCORE on a stable flat surface or install
it into a standard rack.
2. If installing into a rack, attach the brackets to both sides
of the XstreamCORE enclosure. Then install the
XstreamCORE assembly horizontally within the rack so it
does not reduce the air flow within the rack.
E
5 A
XHIBIT
TTACH RACK MOUNTING BRACKETS TO
E
6 I
X
XHIBIT
NSTALL
STREAM
3. Connect the host computer by connecting the cable to FC
port 1, 2, 3, or 4.
4. Connect target devices by connecting SAS cables to SAS
connector A, B, C or D.
5. Power up the target devices.
6. Connect the Ethernet port to your network.
Install the XstreamCORE
X
STREAM
CORE
.
INTO A RACK
7.
Connect the AC power cords from the XstreamCORE to
the proper AC source outlets.
when plugged into an AC outlet.
earth ground and comply with local electrical codes. Improper
grounding may result in an electrical shock or damage to the
unit. Also, be aware that this unit is powered on once a power
source is connected. Make sure the power supply module is
fully inserted before applying power. Failure to do so may cause
injury or damage the unit.
If you are using a rack:
8.
Wait for the XstreamCORE Ready LED to light, indicating
that the XstreamCORE has completed its power-on self
test sequence.
Installation and Removal of Power
Supply Modules
CORE
1.
To remove a power supply module, first remove the
power cord.
2.
Press the side latch inward and pull out on the handle
3.
To install a power module, insert module until you hear
the latch click.
4.
Install power cord.
power supply module. Failure to do so may cause injury or
damage the unit.
Power is automatically supplied to the 7550/7600
The power source must be connected to a protective
Properly ground the XstreamCORE to the rack
equipment. The earth ground connection must be
maintained.
The power requirements plus the power draw of
the other equipment in the rack must not
overload the supply circuit and/or wiring of the
rack.
Handle and latch should be on top.
Remove the power source before removing the
Advertisement
Table of Contents
