ATTO Technology XstreamCORE FC 7550 Installation And Operation Manual page 37

SNMPUsername
Sets the SNMPv3 username and password or displays the
SNMPv3 username. The username must be 1 to 32 characters
long, and may only contain the following: {a-z,A-Z,0-9}. The
password must be 8 to 32 characters long, and may only contain
the following: {a-z,A-Z,0-9}. SNMP must be enabled to run this
command. This command takes 10-15 seconds to complete.
SNMPUsername
SNTP (OEM Configurable, Supported In-Band)
SNTP controls whether SNTP time server functionality is enabled.
set SNTP [enabled | disabled]
get SNTP
SNTPServer (OEM Configurable, Supported In-Band)
SNTPServer sets/displays the IP addresses used to retrieve the
SNTP time. Index range is 1-3 indicating the server slot to
set/display. Enter 0.0.0.0 to disable a time server slot.
set SNTPServer [Index] [IP address]
get SNTPServer <Index | All>
StopIdentifyLUN (Supported In-Band)
Stops lighting the LED(s) of disk drive(s) associated with one or
more FC LUNs.
StopIdentifyLUN [LUN | all]
Temperature (Supported In-Band)
Displays the current internal temperature of the XstreamCORE in
degrees Celsius.
get Temperature
Time (Supported In-Band)
Sets/displays the current time in a 24-hour format. If SNTP is
enabled and at least one ethernet port is connected to a
reachable SNTP time server, the time is retrieved from one of the
configured SNTP time servers, and manual attempts to change
the time will have no effect. If SNTP is disabled or SNTP server
synchronization is not possible, the system time starts from
XstreamCORE's last known system time stamp, and the time may
be changed manually.
set Time [HH :MM :SS]
get Time
TimeZone (OEM Configurable, Supported In-Band)
Sets/displays the time zone or an offset from GMT. GMT offset
must be in the format +/-HH:MM
set TimeZone [[EST | CST | MST | PST] | [[+|-][HH]:[MM]]]
get TimeZone
Uptime (Supported In-Band)
Returns the time [days hrs:min:sec] since the last reboot.
get Uptime
Username (OEM Configurable, Supported In-Band)
Specifies the username used for all sessions: SSH, SFTP and
XstreamVIEW. Username must be all lowercase, 1 to 32
characters long, start with an alphabetical character, and may
only contain the following: {a-z,0-9,-,_,.}.
set Username [username]
get Username
VerboseMode (OEM Configurable, Supported In-Band)
Controls the level of feedback returned by the command line
interface. Disabling this option removes CLI Help command
descriptions and removes CLI command display headers and
parameter names from get and immediate commands.
set VerboseMode [enabled | disabled]
get VerboseMode