Mapping Devices With Smp; Automap Devices - ATTO Technology XstreamCORE FC 7550 Installation And Operation Manual

Mapping Devices with SMP

Drive Map Director assigns a Fibre target number to each
shelf of storage and a Fibre LUN is reserved for each slot
within the enclosure. This numbering scheme is static and will
remain with the shelf and slot location whenever a drive or
shelf is added or removed. This allows maps to remain the
same when shelves or drives need to be swapped out due to
failure and remain consistent during power cycles of the
XstreamCORE.
1. If you are not already in the XstreamVIEW™ interface,
type the IP address of your XstreamCORE in a standard
browser as found in Using XstreamVIEW™ System
Manager, click Enter Here, type in your user name and
password, and click OK.
2. The Status page appears.
3. From the XstreamVIEW™ main menu, click on the
Mapping menu item on the left side of the screen.
4. The Mapping page appears. If your storage supports
SMP, the XstreamVIEW™ System Manager will display
mapping information for your devices.
If your devices do not support SMP you will be able
to use the AutoMap feature to map your storage devices.

AutoMap devices

1. If you are not already in the
XstreamVIEW™ interface, type the
IP address of your XstreamCORE in a
standard browser as found in Using
XstreamVIEW™ System, click Enter
Here, type in your user name and
password, and click OK.
2. The Status page appears.
3. From the XstreamVIEW™ main
menu, click on the Mapping menu
item on the left side of the screen.
4. The Mapping page appears. Wait for
the automatic scan for devices to
complete.
5. Click AutoMap.
6. All the commands necessary to enable mapping are
performed.