Using Ssh; Making An Ssh Connection - ATTO Technology XstreamCORE FC 7550 Installation And Operation Manual

12. To verify that you have connected successfully, type help
after the Ready prompt and press Enter.
If a list of all available commands does not appear
on the screen, review the steps in this section, check the cable,
or contact service personnel until the problem is solved.

Using SSH

Up to two SSH sessions can be conducted simultaneously. A
serial port session can use the CLI while SSH sessions are
open. Whichever session issues the first set CLI command can
continue to issue set commands, while the other sessions can
only issue get commands or display information. Once a
connection is established, refer to
Interface.

Making an SSH connection

1. Start an SSH client.
CLI provides ASCII-based
If you have difficulty using the serial port, verify that
you have the correct settings and that your serial cable is less
then two meters in length.
There is more than one way to connect to the
XstreamCORE using an SSH client. Your SSH client may operate
differently than in the following instructions.
2. In your SSH client, connect to the XstreamCORE. As an
example, using OpenSSH, the connection would be made
with the following command where username is the
username set in Modify
address of the XstreamCORE.
ssh username@x.x.x.x
3. Enter your password.
4. To quit an SSH session, type exit
passwords, and x.x.x.x is the IP