Appendix D Standards And Compliances 7550; Regulatory Notices; Fcc Notices (Us Only); Compliance With Ices-003 - ATTO Technology XstreamCORE FC 7550 Installation And Operation Manual

Appendix D Standards and Compliances 7550

The equipment described in this manual generates and uses radio frequency energy. If this equipment is not used in strict accordance with
the manufacturer's instruction, it can and may cause interference with radio and television reception.

Regulatory Notices

FCC Notices (US only)

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: •
Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the
equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced
radio/TV technician for help. Modifications not expressly approved by the manufacturer could void the user's authority to operate
the equipment under FCC rules.

Compliance with ICES-003

This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.

Compliance with EN Regulations

Marking by the symbol indicates compliance of this ATTO device to the EMC Directive and the Low
Voltage Directive of the European Union.
The ATTO XstreamCORE FC 7550/7600 complies with Directive 2011/65/EC on the Restriction of the Use of Hazardous Substances in
Electrical and Electronic Equipment RoHS2 (recast) and take the following exemptions:
6(c)- Copper allot containing up to 4% lead by weight.
7(a) -Lead in high melting temperature type solders (i.e. lead based alloys containing 85% by weight or more lead).
7(c)-l -Electrical and electronic components containing lead in a glass or ceramic other than dielectric ceramic in capacitors, e.g.
piezoelectronic devices, or in glass or ceramic matrix compound.
15 - Lead in solders to complete a viable electrical connection between semiconductor die and carrier within integrated circuit flip
chip packages.
UL60950-1/CSA C22.2 No. 60950-1
The product has been certified and bears the Mark, as applicable, of the EMC and Product Safety authorities as indicated below:
-1 -1 -1
Safety: TUV 72141224, EN 60950 , CE, CSA 60950 , UL 60950 , CB IEC60950-1 (all national deviations)
A 3
Emissions/Immunity: FCC Part 15 Class , ICES-003, CE - EN550 2, EN55024, IEC61000-3-2, IEC61000-3-3