Command Explanations - ATTO Technology XstreamCORE FC 7550 Installation And Operation Manual

SerialPortEcho
SNMP
SNMPDumpEngineID
SNMPDumpMIB
SNMPExtendedTraps
SNMPTrapAddress
SNMPTraps
SNMPUsername
SNTP
SNTPServer
StopIdentifyLUN
Temperature
Time
TimeZone
Uptime
Username
VerboseMode

Command explanations

AutoMap (Supported In-Band)
Automatically maps a subset of target devices visible to the
firmware to a set of Fibre Channel LUNs. All previous maps will be
deleted.
AutoMap
enabled get seriallportecho
disabled set SNMP enabled
SNMPDumpEngineID
snmpdumpmib
disabled get snmpextendedtraps
0.0.0.0 none set snmptrapaddress 6 192.42.155.155 all
disabled set snmptraps enabled
Set SNMPUsername bob
enabled get sntp
129.6.15.30 set sntpserver 129.6.15.30
StopIdentifyLUN all
get temperature
set time 03:32:30
EST set timezone pst
get uptime
admin set username Barbara
enabled set verbosemode disabled
BootFibreDelay (OEM Configurable, Supported In-Band)
Sets the delay (in seconds) after startup before enabling the Fibre
Channel ports. The value "0" constitutes no delay.
set BootFibreDelay [0-255]
get BootFibreDelay
ClearCLILog (Supported In-Band)
Clears the contents of the CLI command log.
ClearCLILog
ClearEventLog
ClearEventLog clears the contents of the event log.
ClearEventLog
ControllerLUN (OEM Configurable, Supported In-Band)
Controls the automatic generation of a controller device at LUN
0. After enabling or disabling the controller LUN, save
configuration and run automap to re-map all devices.
set ControllerLUN [enabled | disabled]
get ControllerLUN