ATTO Technology XstreamCORE FC 7550 Installation And Operation Manual page 35

MinOpTemp (OEM Configurable, Supported In-Band)
Regulates/displays the minimum enclosure temperature alarm of
the XstreamCORE in degrees Celsius.
set MinOpTemp [0-15]
get MinOpTemp
OEMConfigFile (Supported In-Band)
Returns the "name" (the contents of the first record) of the OEM
configuration file stored in persistent memory.
get oemconfigfile
OpTempWarn (OEM Configurable, Supported In-Band)
Regulates/displays the number of degrees in Celsius before a
warning is sent to the user.
set OpTempWarn [0-15]
get OpTempWarn
Password
Specifies the password used for all sessions: SSH, SFTP and
XstreamVIEW. The password must be 8 to 32 characters long,
must contain at least one numeric character {0-9}, and may not
contain the following: {space,tab,',\,;}.
set Password
Performance (Supported In-Band)
Returns system performance data. Data consists of the average
rate (MB/s) and number of I/Os (IO/s) measured over the
previous sampling period (approximately one second). Successful
SCSI Read (28h, 88h, A8h) and Write (2Ah, 8Ah, AAh) commands
are considered I/Os. Factors that may affect reported
performance include port availability and saturation, transfer
size, target device speeds, and overall system utilization.
get Performance
Ping
Sends an ICMP echo request to the specified host.
Ping [mp[n]] [IP Address]
ReadOnlyPassword
Specifies the password used for all sessions: SSH, SFTP and
XstreamVIEW. The password must be 8 to 32 characters long,
must contain at least one numeric character {0-9}, and may not
contain the following: {space,tab,',\,;}.
set ReadOnlyPassword
ReadOnlyUsername (OEM Configurable, Supported In-Band)
Specifies the username used for all sessions: SSH, SFTP and
XstreamVIEW. Username must be all lowercase, 1 to 32
characters long, start with an alphabetical character, and may
only contain the following: {a-z,0-9,-,_,.}.
set ReadOnlyUsername
get ReadOnlyUsername
Reserve (Supported In-Band)
Prevents other CLI sessions from modifying the XstreamCORE.
When the XstreamCORE services interface is reserved, set
commands are unavailable to other sessions, but get commands
are available. Executing a SaveConfiguration or
RestoreConfiguration command releases the XstreamCORE so
that other CLI sessions may make setting changes.
Reserve
ResetFCPortErrors (Supported In-Band)
Resets all FC error counts for the specified port to zero.
ResetFCPortErrors [fp | all]
RestoreConfiguration (Supported In-Band)
Restores configuration to either the default configuration or the
configuration last saved into non-volatile memory. The saved
option undoes any changes made since the last save.
RestoreConfiguration [Default | Saved]
RouteDisplay (Supported In-Band)
Displays a list of Fibre Channel to SCSI address mappings on the
XstreamCORE.
RouteDisplay FC
SASConnectorInfo (Supported In-Band)
SASConnectorInfo displays information about the specified SAS
connector. Valid connector names are A through D.
get SASConnectorInfo [sasConn | all]
SASEnclosures (Supported In-Band)
Displays a list of attached enclosures. If no arguments are
specified, only the enclosure summary table is displayed. If PHYID
is specified, this displays connection details for active PHYs. If
SlotMap is specified, device details for enclosure slots are
displayed. EncIdx displays details for the specified enclosure.
SASEnclosures < [PHYID | SlotMap] <EncIdx> >