Rotor Assembly - JLG TOUCAN 8E Service And Maintenance Manual

Rotor Assembly

d=31 mm
1" 1/7
D=45 mm
1" 3/4
Figure 4-14. Rotor Assembly
1. Position a sleeve (13) on the encoder.
2. Install the rotor until its abutment in the housing
using a mallet.
3. Install the retaining ring (10), the key (11) the gear
(9) and the retaining ring (8).
(See Figure 4-10. Rotor Disassembly)
4. Position the encoder cable into the cable seal.
Stator Assembly
1. Place the stator (4) on the rear casing and rotor
assembly (7) and insert the cable encoder into the
cable seal (17).
(See Figure 4-9. Stator Disassembly)
2. Position the cable seal (17) into the casing (3) hous-
ing.
3. Complete the stator (4) installation.
31210090
H=40 mm
1" 3/4
SECTION 4 - CHASSIS MOUNTED COMPONENTS
Motor Assembly:
NOTE: Prior to install the motor, see the following paragraph
"Oil Filling".
Figure 4-15. Motor Sealing
1. Insert the spring washer (19) above the lip seal (18)
and grease with Mobilux EP2.
2. Turn the motor so that the cables are on the same
side as the gearbox boss.
Figure 4-16. Motor Positioning
3. To authorize insertion, turn the motor or the brake
drive gear so that the gears intermesh.
4. Screw staggered the 4 screws (1) of the motor
(torque value: 16 N.m ± 2.4 N.m).
5. The new encoder should be equipped with contacts
Deutsch JLG P/N 4460917. Re-wire the encoder
connector (See Fig. 4-8).
Brake Assembly:
1. (see procedure on the previous paragraph "Brake
Assembly").
– JLG Lift –
4-5