JLG TOUCAN 8E Service And Maintenance Manual page 147

DTC FAULT MESSAGE
2310 FUNCTION PROBLEM -
GROUND ENABLE PERMA-
NENTLY SELECTED
2368 FUNCTION PROBLEM - MAST
LIFT UP PERMANENTLY
SELECTED
2369 FUNCTION PROBLEM - MAST
LIFT DOWN PERMANENTLY
SELECTED
2370 FUNCTION PROBLEM - JIB
LIFT UP PERMANENTLY
SELECTED
2371 FUNCTION PROBLEM - JIB
LIFT DOWN PERMANENTLY
SELECTED
2372 FUNCTION PROBLEM -
SWING LEFT PERMANENTLY
SELECTED
2373 FUNCTION PROBLEM -
SWING RIGHT PERMA-
NENTLY SELECTED
31210090
DESCRIPTION
The Ground Enable switch was closed
during power-up in ground mode.
The Mast Lift Up switch was closed
during power-up in ground mode.
The Mast Lift Down switch was closed
during power-up in ground mode.
The Jib Lift Up Switch was closed during
power-up in ground mode.
The Jib Lift Down switch was closed
during power-up in ground mode.
The Swing Left switch was closed during
power-up in ground mode.
The Swing Right switch was closed
during power-up in ground mode.
– JLG Lift –
SECTION 10 - DIAGNOSTIC TROUBLE CODES
• Check if the concerned switch is damaged,
obstructed or jammed.
• Disconnect the membrane panel ribbon cable :
replace the membrane panel if DTC is no longer
present.
• Check the switch line voltage : J3(4), CR1(9) and
CR3(19).
• Check if the concerned switch is damaged,
obstructed or jammed.
• Disconnect the membrane panel ribbon cable :
replace the membrane panel if DTC is no longer
present.
• Check the switch line voltage : J3(6), CR1(21) and
CR3(20).
• Check if the concerned switch is damaged,
obstructed or jammed.
• Disconnect the membrane panel ribbon cable :
replace the membrane panel if DTC is no longer
present.
• Check the switch line voltage : J3(7), CR1(22) and
CR3(32).
• Check if the concerned switch is damaged,
obstructed or jammed.
• Disconnect the membrane panel ribbon cable :
replace the membrane panel if DTC is no longer
present.
• Check the switch line voltage : J3(8), CR1(30) and
CR3(17).
• Check if the concerned switch is damaged,
obstructed or jammed.
• Disconnect the membrane panel ribbon cable :
replace the membrane panel if DTC is no longer
present.
• Check the switch line voltage : J3(9), CR1(31) and
CR3(16).
• Check if the concerned switch is damaged,
obstructed or jammed.
• Disconnect the membrane panel ribbon cable :
replace the membrane panel if DTC is no longer
present.
• Check the switch line voltage : J3(11), CR1(33) and
CR3(29).
• Check if the concerned switch is damaged,
obstructed or jammed.
• Disconnect the membrane panel ribbon cable :
replace the membrane panel if DTC is no longer
present.
• Check the switch line voltage : J3(10), CR1(32) and
CR3(31).
CHECK
10-5