Maintenance Screen 1; Maintenance Screen 2; Maintenance Screen 3 - Graco ProMix PD2K Electronic Operation

Maintenance Screen 1

Use this screen to set maintenance intervals. Set
to 0 to disable the alarm.
NOTE: The Pump Stall Test cannot be disabled. You
must enter a value other than 0.
Figure 56 Maintenance Screen 1, Interval Settings

Maintenance Screen 2

Maintenance screen 2 shows the current interval
status of the solvent meter, fluid filter, and air filter.
Press and hold the Reset button
seconds to clear the alarm and reset the counter.
Figure 57 Maintenance Screen 2, Current Status
332562B

Maintenance Screen 3

Maintenance screen 3 shows the current interval
status of the pump maintenance tests.
Press and hold the Reset button
seconds to clear the alarm and reset the counter.
NOTE: The Pump Stall Test can only be reset by
successfully completing the test.
Figure 58 Maintenance Screen 3, Current Pump
Status
for 1-2
Setup Mode Screens
for 1-2
53