System Screen 1 - Graco ProMix PD2K Electronic Operation

System Screen 1

System screen 1 includes the following fields which
define your system.
Figure 29 System Screen 1, During Standby
Figure 30 System Screen 1, During Idle
332562B
Diagnostic Mode
Select this box to display flow rate and pressure for
each pump on the Home Screen, page
Color Pumps
Enter the number of color pumps in your system.
Catalyst Pumps
Enter the number of catalyst pumps in your system.
Non-Mix Pressure
Enter a lower pressure for use when not mixing and
spraying (for example during fill or flushing).
NOTE: Low pressure systems may be set 100 psi
(0.7 MPa, 7 bar) lower than target pressure; high
pressure systems may be set 300 psi (2.1 MPa, 21
bar) lower than target pressure.
Solvent Meter
Select this box if your system uses a solvent meter.
The Solvent K-Factor field will then become active.
Solvent K-Factor
Enter the solvent meter K-Factor.
Select Gun Flush Box
Select this box if your system uses a gun flush box.
The Autodump function will then become selectable.
Autodump
Select this box to activate the Autodump function.
Setup Mode Screens
31.
39