Basic Configuration - Mitel CPDM3 Installation Manual

Installation Guide
10 Click "Install this driver software anyway". The installation of the port driver
begins.
11 Click "Close" when the installation has finished.
12 The port driver "Linux USB Ethernet/RNDIS Gadget" is now installed in Control
Panel > Hardware and Sound > Devices and Printers > Device manager >
Network adapters
.

4.5 BASIC CONFIGURATION

The product needs to be configured with basic settings. Some settings can be set in the
Setup Wizard accessible from the web interface. The Setup Wizard starts automatically
the first time the product is accessed from the web browser and every time until the
configuration has been saved. Follow the wizard and fill in the required data (IP
address, NTP server, license etc.). After it has been saved the wizard can always be
opened from the Start page. Other settings are set from the product's configuration
page and are described in the product's manual.
4.5.1 SETUP VIA SETUP WIZARD
1 Access the product either via the network or via the management port, see
Accessing Product
2 Enter user name "admin" and the password "changeme".
3 Complete the Setup Wizard.
NOTE: If the product's network IP address has not been assigned by an DHCP server,
it must be set manually in the wizard. If manually set, the IP address
192.5.36.229 cannot be assigned to the product when it is connected to the LAN.
That IP address is reserved for accessing the product via the management port
only.
34/1531-ANF901 43 B1 2016-03-31
on page 19.
TD
4.4
23