Working In Boot Mode; Set Product In Boot Mode - Mitel CPDM3 Installation Manual

Installation Guide

5. WORKING IN BOOT MODE

If the software installed on the product cannot be started, the Boot Mode can be used
for installing new software, see settings, performing factory reset, troubleshooting and
also starting up in normal operation again. If the product detects several major errors
(for example restart loop), the product can set itself in Boot Mode.

5.1 SET PRODUCT IN BOOT MODE

The description below starts with a controlled restart. The operation takes
approximately 5 minutes.
1 Press the Restart button and release it within 4 seconds (use a paper clip or
similar).
The status LED will first indicate shutting down with quick flashing blue light
2 Wait for one minute until the status LED indicates starting up with quick flashing
blue light
The Mode button LED will lit and show fixed blue light
3 Then wait until the status LED changes to quick flashing yellow light
which indicates that the module has started in Boot Mode (after approximately
one minute).
4 Enter the product's IP address in a web browser.
If this operation does not work, pressing the mode button after an initiated forced
restart can be used as a last resource, see
5.1.1 SYSTEM INFORMATION
Under System > Information the reason for why the product is in Boot Mode, the
module key number, MAC address, Boot software version, etc. are shown.
Figure 12. System information in Boot Mode.
34/1531-ANF901 43 B1 2016-03-31
and then "waiting" with flashing yellow light
, then press the Mode button.
7.2.2 Forced Restart on page 30.
TD
.
.
,
25