Mounting And Connecting The Hydraulic Drive Unit - Raven CRX ROS+RS1 Installation Manual

CRX/VIPER4+ ROS INSTALLATION | CRX/VIPER 4+ ROS - RS1 | RAVEN EUROPE GENERIC
1.2.7 MOUNTING AND CONNECTING THE
HYDRAULIC DRIVE UNIT.
The Hydraulic Drive Unit bracket can be mounted to
the manifold. The Hydraulic Drive Unit can then be
fitted to the manifold bracket (Figure 13).
Important notes when mounting the Unit:
Mount the Hydraulic Drive Unit with
•
connectors directed downwards to prevent the
ingress of water!
Do not mount the Hydraulic Drive Unit too
•
close to parts which have a high temperature
(for example, the exhaust system of the
tractor)!
Connect the DIN connectors marked "Left" and "Right"
to the proportional valve. Connect the DIN connector
marked "Lock" to the shut-off valve. Connect the 4-pin
Phoenix M12 connector to the pressure sensor of the
manifold.
Please note!:
The torque of the pressure sensor in the
manifold V3 is 30 Nm. It is not necessary to
check this at delivery of an assembled
manifold. However, make sure, when replacing
the pressure sensor, that it is tightened with
the correct torque.
Raven Industries Inc.
FIGURE 13 SIDE VIEW OF THE HYDRAULIC DRIVE
UNIT FITTED TO THE MANIFOLD
PAGE 18/36 | Installation manual | 016-8000-028EN | Rev. B