Table of Contents
Advertisement
CRX/VIPER4+ ROS INSTALLATION | CRX/VIPER 4+ ROS - RS1 | RAVEN EUROPE GENERIC
1 STEERING SYSTEM INSTALLATION
This chapter describes the installation of all the
different steering systems, hydraulic and SmarTrax MD.
Look carefully at the system overviews to know which
parts of the installation are applicable.
MOUNTING HARNESSES
When installing an autosteer system, the power cables
should always be connected to the battery. Two
options are possible, a Basic Harness (1-115-8000-141)
or an Implement Ready Harness (1-115-8000-060
frontmount or 1-115-8000-315 midmount). The
differcence between these harnesses is the IBBC
connector, this one is included at an Implement Ready
(IR) Harness (Figure 1).
Power harness: an Implement Ready power harness is
mounted from the battery to the rear of the tractor. A
Basic power harness is mounted from the battery to
the chassis harness. Make sure that the relays and
fuses are mounted in a dry, clean and accessible spot
(Figure 2).
The harness that is connected to the Power Harness
depends on the steering type that will be installed. For
system overviews, see pages 6 - 13. All the harnesses
with a hard casing should be mounted outside the
cabin, all the harnesses with a braided sleeve should
be mounted inside the cabin. At all time, find a good
location where the cabling can enter the cabin.
In addition, several guidelines have been established
for the assembly of all types of cable harnesses:
Mount the relays fixed and in a dry, clean and
•
accessible spot (Figure 2).
The red wire is + (12V). The black wire is minus
•
(ground). Make sure that the first part of the
red wire (part in between battery and fuses)
cannot damage during operation.
PAGE 11/36 | Installation manual | 016-8000-028EN | Rev. B
FIGURE 1 IBBC CONNECTOR
FIGURE 2 CORRECT MOUNTED RELAYS AND FUSES
Advertisement
Table of Contents
