Rear Mounting Options - Kärcher MIC 50 Manual

Interchangeable frame for the attachment
1
Fixing hook (2x)
2
Attachment frame
3
3. Cautiously lift the attachment frame until the front support feet
come off the ground, whist making sure that the fixing hooks
engage in the attachment frame.
4. Finally, check the secure fit of the fixing hooks.
5. Remove the front supports from the attachment.
Attachment
1
Rear supports
2
Locking device for attachment (2x)
3
6. Get in, and completely lower the attachment frame.
7. Remove the rear supports from the attachment.
Retaining pin (2x)
1
Retaining clip (2x)
2
8. Secure the attachment to the left and right (retaining pin and
retaining clip are a part of the attachment frame).
During first installation or when changing the carrier vehicle,
the fixing must be set, see chapter 9.4.3 Setting the fixing.
9. Deal with the hydraulic and electrical connections after doing
the fitting.
68
9.4.5 Removing the attachment from the vehicle
Front supports
1
Rear supports
2
1. Completely lower the attachment frame.
2. Disconnect the hydraulic and electrical connections prior to
the dismantling.
3. Remove the retaining pins to the left and right.
4. Insert the two rear supports as far as they will go.
5. Lift the attachment frame far enough until the front supports
can be inserted.
6. Get in, and completely lower the attachment frame.
7. Insert the two front supports as far as they will go.
8. Lower the attachment frame.
9. Cautiously drive the vehicle out.
9.5

Rear mounting options

9.5.1 Rear mounting frames
Counterweights and certain attachments can be attached directly
to the mounting frame for attachments.
Mounting frames
1
1. Push the attachment into the mounting frames and secure us-
ing 2 bolts.
9.5.2 Tow bar
ATTENTION
Make sure when coupling and decoupling that nobody is in the
hazard zone.
English