Section 1 - Installation; Unpacking The System; Utilities Required; Tools/Equipment Required - Ametek Chandler Engineering 4207D Operating Manual

Digital compressive strength tester

Hide thumbs Also See for Chandler Engineering 4207D:

Table of Contents

Section 1 – Installation

Carefully unpack the Model 4207D and all of its accessories. Visually inspect for any

damage that may have occurred during shipping. After the instrument is removed from the

shipping crate, the equipment and spare parts should be checked against the packing list to

insure that all parts have been received and none are damaged.

Remove the front cover of the instrument to remove the circuit board and spare parts that are

individually wrapped to prevent damage during shipment. Slide the circuit board into the

backplane as illustrated below; then replace the front cover.

Note: File an insurance claim with your freight carrier if damage has occurred

during shipping. Verify all parts shown on the enclosed packing list have been

received. If items are missing, please notify Chandler Engineering

immediately.

Electrical:

No special tools are required for the installation of the Model 4207D. Standard hand tools

are sufficient.

Connect the power cord to an approved grounded receptacle in accordance with local wiring

codes. Model 4207D-60Hz is intended for use on, 200-240 VAC 60 Hz and Model 4207D-

50Hz is intended for use on, 200-240 VAC 50 Hz.

200-240 VAC, 50 Hz or 60 Hz, depending on model.

SECTION 1 – INSTALLATION

1-1

Table of Contents