Section 2 - Operating Instructions; Programming The Controller - Ametek Chandler Engineering 4207D Operating Manual

Section 2 - Operating Instructions

Before operating the 4207D it is necessary to be familiar with the press controller and load
indicator features and controls.

Programming the Controller

The Model 7052 controller used with the 4207D system features user defined segment
programming (8 segments maximum). Using these segments, sample load ramp and dwell
segments are defined.
Controller Feature
Output 1 or 2:
Upper Readout
(Process Value)
Lower Readout or
(Setpoint Value)
Remote Communication
Auto/Manual Button
Run/Hold Button
Page Button
Scroll Button:
Up/Down Buttons:
Setpoint 2
SECTION 2 – OPERATING INSTRUCTIONS
Description of Feature
Not active.
Displays the current value of the sample load. This
value must be multiplied by 10 to indicate pounds-
force (Lbf).
Indicates the current set point value. Indicates alarm
condition in the event of an alarm.
Indicates remote communication if the system is
equipped with this option.
Changes the mode of the controller from Automatic
to Manual. When the controller is not being used,
place the controller in Manual mode and verify that
the lower readout displays Off.
Used to Run, Hold, or Terminate a program. Press
once to Run the program. Press again to Hold the
program. Press for over 3 seconds to terminate the
program.
Used to page through the various menus in the
controller.
Used to scroll through the parameter settings within a
menu page.
Used to change the value of a parameter. Press and
hold the button for rapid changes to a value.
Not used
2-1