Table of Contents
Advertisement
Printing on FS-101 Fabric Sheets
Follow these steps to load and print on Canon's FS-101 fabric sheets.
N
Read and follow the precautions and handling instructions included
with the FS-101 fabric sheets.
Do not use the fixing agent that is supplied with the FS-101 fabric
sheet. This agent is not needed when printing with the MultiPASS
C20.
Do not touch the printing on a newly printed fabric sheet until the
ink has dried completely (normally about an hour).
1.
Open the printer cover by grasping the document guides and lifting.
2.
With the cloth side facing you and the open end up, insert one sheet
into the sheet feeder until it stops, and align the paper guide with
the edge of the sheet. You are now ready to print.
2-50
Setting Up Your MultiPASS C20
Make sure the paper thickness lever is set to the right. See
"Adjusting the Paper Thickness Lever" on page 2-40.
OPEN END AT THE TOP
Chapter 2
Advertisement
Table of Contents
