Preparing To Send A Fax; Resolution; Setting The Resolution - Canon MultiPASS C20 User Manual

Preparing to Send a Fax

Before you can send a fax, you need to load the document into the
MultiPASS C20's Automatic Document Feeder (ADF). For instructions
and information about the types of documents the MultiPASS C20 can
scan, see "Types of Documents You Can Scan" on page 4-2.

Resolution

Canon's Ultra High Quality (UHQ™) imaging technology enables you
to send faxes with a print quality that is very close to that of the original
document. The MultiPASS C20 also lets you adjust the resolution it uses
in sending faxes to best suit your particular document.

Setting the Resolution

The MultiPASS C20 has three resolution settings:
STANDARD resolution (8 pels/mm 3.85 lines/mm) is adequate
for most text documents.
FINE resolution (8 pels/mm 7.7 lines/mm) is suitable for
documents with fine print (smaller than the print in this sentence).
PHOTO resolution (8 pels/mm 7.7 lines/mm, with halftones) is
for documents that contain photographs. With this setting, areas of
the document that contain photos are automatically scanned with 64
levels of grey, rather than just two (black and white). This gives a
much better reproduction of the photos, though transmission time is
longer.
Set the resolution as follows:

RESOLUTION

1. Press RESOLUTION.
N
When the RESOLUTION button is pressed, the LCD display shows the
current resolution for about five seconds before returning to standby
mode.
Chapter 3
The LCD display shows the current scanning resolution.
STANDARD
Sending and Receiving Faxes
3-3