Table of Contents
Advertisement
If using coded speed dialling:
2.
Press CODED DIAL:
CODED DIAL
3.
Use the numeric buttons to enter the two-digit code assigned to the
ABC
DEF
1
2
3
fax number:
GHI
JKL
MNO
4
5
6
PQRS
TUV
WXYZ
7
8
9
0
4. Press START/COPY.
N
You can also use the one-touch speed dialling buttons and speed
dialling codes to send a document to more than one fax number at a
time. For details, see "Sequential Broadcasting" on page 3-26.
Chapter 3
03
The number registered under that coded speed dialling code is
displayed.
If you make a mistake while dialling, press the
button. Then press the correct one-touch speed dialling button
or press CODED DIAL and enter the correct code.
If no fax number is assigned to the one-touch dialling button
you press or the code you enter, the LCD displays the
following:
NO TEL #
If this happens, make sure you pressed the correct button or
entered the correct code, and that the number you want to dial
is registered to that button or code.
DIALING
If you do not press the
seconds, the MultiPASS C20 will begin sending automatically.
If an error occurs during sending, the MultiPASS C20 will print
an error report. If this happens, try sending the fax again. See
"Faxing Problems" on page 6-22 for details about errors.
The display then shows TX, the number of pages it has scanned,
and the transaction number.
(START/COPY) button within five
Sending and Receiving Faxes
(STOP)
3-23
Advertisement
Table of Contents
