Resetting To Factory Defaults - HP Digital Sender 8100C Administrator's Manual

To shut down
1
2
3
4
5
Note A shutdown key sequence exists that will shut down the digital sender
if it becomes unresponsive and therefore will not navigate to the
Shutdown option. The code is:

Resetting to factory defaults

Use this procedure for the following reasons:
Resetting the digital sender to factory defaults is a combination of
resetting address books and resetting network parameters. It does
the following:
Notes about the procedure:
CAUTION This action cannot be undone.
All manuals and user guides at all-guides.com
Make sure the digital sender is idle.
At the control panel, press
(F2).
Select any of the configuration menus. If an administrator
password is required, the HP Digital Sender 8100C
Administrator's Password dialog box appears. Type the
password and press
When the configuration menu appears, press
Select Shutdown and press
when you want to completely reconfigure the digital sender and
all address books
when instructed to do so by troubleshooting steps or
HP customer support
erases the administrator password
locks the digital sender from use until the reset is complete
erases the configuration for TCP/IP, DNS/WINS, security, e-mail,
fax, and LDAP settings
erases the contents of all public and personal address books,
distribution lists, and phone books.
After you reset the digital sender to the factory defaults, neither
you nor any users can use the digital sender again until you have
reconfigured it, starting with the steps under
parameters" on page
S (A +F4). Then press
ETUP LT
O (F1).
K
O (F1).
K
S +A +
HIFT LT
20.
Administrator tools
S
ETTINGS
T (F2).
OOLS
.
"Configure e-mail
37